Ford Kuga

 Service Manual

Instrument Cluster » Instrument Cluster
Configuration of the Instrument Cluster

The instrument cluster is a programmable module, which must be configured by selecting the Programmable Module Installation Routine on the Ford approved diagnostic tool.

NOTE: When the new instrument cluster has been configured with the odometer value, its configuration cannot be decreased or matched. A new configuration will result in an increase in the displayed odometer value by a minimum of two units.

NOTE: The odometer value must be recorded from the original instrument cluster before removal.

If the odometer value cannot be obtained from the original instrument cluster (display failure) the customer should supply the approximate value.

The following features will need to be configured when a new instrument cluster is installed:

• Anti-lock Brake System (ABS)
• All wheel drive
• Keyless vehicle entry
• Electronic power assisted steering
• Trip computer
• Voice control
• Parking aid
• Belt minder
• Safety belt not fastened
• Right hand drive
• Overspeed warning
• Reverse warning
• Turbocharger boost pressure
• Speed control
• Auxiliary heater
• Suspension control
• Washer fluid sensor
• Navigation
• Fuel cap release
• Engine type
• Display language

In addition the new instrument cluster will require the original odometer value to be entered.

After the installation and configuration of a new instrument cluster. The passive anti-theft system (PATS) will require programming by selecting the Security Access routine on the Ford approved diagnostic tool.

General Equipment

Ford Diagnostic Equipment

General Equipment

Round-Ended Steel Rule

Removal

1. NOTE: This step is only necessary when installing a new component.

Upload the instrument cluster configuration information using the Programmable Modules Installation Routine.

General Equipment: Ford Diagnostic Equipment 2. NOTE: This step is only necessary when installing a new component.

Record the odometer value from the original instrument cluster. If the odometer value cannot be obtained from the instrument cluster (display failure), the customer should supply the approximate odometer value.

5. General Equipment: Round-Ended Steel Rule

Installation

1. To install, reverse the removal procedure.

2. NOTE: This step is only necessary when installing a new component.

Download the instrument cluster configuration information to the newly installed instrument cluster using the programmable modules installation routine.

Inspection and Verification

Configuration of the Instrument Cluster