Ford Kuga

 Service Manual

Module Configuration
Programmable Module Installation

Activation

5. Install the most up-to-date software version in IDS.

6. If, before replacing a module, it was not possible to read out the vehicle-specific data using the integrated diagnostic system (IDS) (the module to be replaced does not respond) then, during programming of the new module, the vehicle-specific data must be entered manually via a selection list in IDS or via a code which can be obtained from the Technical Hotline.

7. In order to program, select the "Install programmable module" submenu in the "Module programming" menu tool box and then follow the instructions.

8. The following modules must be programmed after replacement:

• Anti-lock braking system module (ABS)
• Audio system module (ACM)
• CD player (CDP)
• Driver's door control unit (D-DCU)
• Passenger's door control unit (P-DCU)
• Rear left door control unit (RL-DCU)
• Rear right door control unit (RR-DCU)
• Electrical power steering (EPS)
• Generic Display Module (GDM) (vehicles with DVD navigation system with touchscreen)
• Generic electronic module (GEM)
• Headlamp control module (HCM) (vehicles with gas discharge headlamps)
• Instrument cluster (IC)
• Navigation system (NAV) (vehicles with navigation system)
• Parking aid module(PAM)
• Powertrain control module (PCM)
• Restraint control module (RCM)
• Rear entertainment system module (RETM) (vehicles with rear seat entertainment system)

9. In order to configure the PCM, select the "Programmable parameters" submenu in the "Module programming" menu tool box and then follow the instructions.

10. For vehicles with anti-lock braking system and electronic stability program, these must also be configured using IDS following replacement of the lateral acceleration sensor, yaw rate sensor or pressure sensor. Configuration is performed in the "Programmable parameters" menu tool box.

Module Configuration

Programmable Module Installation