Ford Kuga
Service Manual
Anti-Lock Control - Stability Assist
Stability Assist Module

General Equipment

Ford approved diagnostic tool

Pneumatic Vacuum Gun

Materials

Name	Specification
Metal Adhesive Kit - 2 Component	WSK-M2G342-A / 2U7J-M2G400-AA

Removal

1. Refer to: Hydraulic Control Unit (HCU) (206-09 Anti-Lock Control - Stability Assist, Removal and Installation).

Stability Assist Module

3. Clean the HCU contact surface.

Material: Metal Adhesive Kit - 2 Component (WSK-M2G342-A / 2U7J-M2G400-AA) cleaner 4. Remove all traces of the cleaner and foreign material.

General Equipment: Pneumatic Vacuum Gun

Installation

WARNING: Make sure that the module is correctly located on the hydraulic control unit (HCU).

CAUTION: If accidentally dropped or knocked install a new hydraulic control unit (HCU) and module.

Take extra care not to damage the seal.

NOTE: Make sure that the seal is correctly located.

Torque: 5,5 Nm

Stability Assist Module

2. Refer to: Hydraulic Control Unit (HCU) (206-09 Anti-Lock Control - Stability Assist, Removal and Installation).

3. Configure the stability assist program.

General Equipment: Ford approved diagnostic tool

4. Carry out the stability assist program Function Test.

General Equipment: Ford approved diagnostic tool

5. Carry out a road test.

Refer to: Road/Roller Testing (100-00 General Information, Description and Operation).

More about «Anti-Lock Control - Stability Assist»:

Anti-Lock Control - Stability Assist (Overview)