Ford Kuga

 Service Manual

Engine System - General Information
Ultraviolet (UV) Testing

1. Clean the engine and transmission with a suitable cleaning fluid.

2. Pour the UV-test fluid in accordance with the quantity specified by the manufacturer through the oil filler neck into the engine and install the oil filler cap.

WARNING: Vehicles with manual transaxle, shift the transaxle into Neutral. Failure to follow this instruction may result in personal injury.

3. Start the engine and let it run for about five minutes.

4. Switch off the engine.

NOTE: If no leak can be found, road test the vehicle under various loads and check the engine for leaks again.

5. Check the engine for oil leaks using a suitable UV lamp.

6. Rectify any leaks found and check the engine for oil leaks.

Engine - Oil Leaks

Ultraviolet (UV) Testing

Measure the compression pressure

Measure the compression pressure (Engine - 2.5L Duratec-ST (VI5)

Measure the compression pressure (Engine - 2.0L Duratorq-TDCi (DW) Diesel)

Measure the oil pressure (Engine - 2.5L Duratec-ST (VI5)

Measure the oil pressure (Engine - 2.0L Duratorq-TDCi (DW) Diesel)