Ford Kuga

 Service Manual

Electronic Engine Controls
Camshaft Position (CMP) Sensor

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

CAUTION: Make sure that the inside of the pipe ends are clean and free of oil residue.

CAUTION: Make sure that the inside of the pipe ends are clean and free of oil residue.

1. Torque: 10 Nm

2. Torque: 4 Nm

3. Torque: 10 Nm

4. Torque: 10 Nm

5. Torque: 10 Nm

Installation

1. NOTE: Make sure that the sensor housing is clean and free of foreign material.

To install, reverse the removal procedure.

Electronic Engine Controls (Component Location)

Electronic Engine Controls (Overview)

Electronic Engine Controls (System Operation and Component Description)

Electronic Engine Controls

Camshaft Position (CMP) Sensor

Catalyst Monitor Sensor

Crankshaft Position (CKP) Sensor

Heated Oxygen Sensor (HO2S)

Knock Sensor (KS)

Mass Air Flow (MAF) Sensor

Powertrain Control Module (PCM)

Variable Valve Timing (VVT) Oil Control Solenoid

Brake Pedal Position (BPP) Switch

Clutch Pedal Position (CPP) Switch