Ford Kuga

 Service Manual

Electronic Engine Controls
Powertrain Control Module (PCM)

General Equipment

3.5 mm Drill Bit

Center Punch

Ford Diagnostic Equipment

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. NOTE: This step is only necessary when installing a new component.

Download the PCM and throttle body configuration information into the diagnostic tool, using the Programmable Modules Installation routine.

General Equipment: Ford Diagnostic Equipment 2. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

Vehicles without PCM security shield

6. Torque: 7 Nm

Vehicles with PCM security shield

7. Refer to: Air Cleaner (303-12 Intake Air Distribution and Filtering - 2.5L Duratec (147kW/200PS) - VI5, Removal and Installation).

8. 1. General Equipment: Center Punch 2. General Equipment: 3.5 mm Drill Bit

Installation

1. To install, reverse the removal.

Vehicles with PCM security shield

2. Tighten the shear bolt until the shear bolt head is sheared off.

All vehicles

3. NOTE: This step is only necessary when installing a new component.

Upload the PCM and throttle body configuration information into the PCM, using the Programmable Modules Installation routine.

General Equipment: Ford Diagnostic Equipment

Electronic Engine Controls (Component Location)

Electronic Engine Controls (Overview)

Electronic Engine Controls (System Operation and Component Description)

Electronic Engine Controls

Camshaft Position (CMP) Sensor

Catalyst Monitor Sensor

Crankshaft Position (CKP) Sensor

Heated Oxygen Sensor (HO2S)

Knock Sensor (KS)

Mass Air Flow (MAF) Sensor

Powertrain Control Module (PCM)

Variable Valve Timing (VVT) Oil Control Solenoid

Brake Pedal Position (BPP) Switch

Clutch Pedal Position (CPP) Switch