Ford Kuga

 Service Manual

Front Drive Halfshafts
Inner Constant Velocity (CV) Joint Boot (14 336 0)

Special Tool(s) / General Equipment

	204-169 Clamping Tool, Boot Retaining Clamp
	308-046 Installer, Transmission Extension Housing Bushing/Seal
Flat-bladed screwdriver
Puller
Materials
Name	Specification
Grease FD-R	WSS-M1C259-A1 / 3M5J-M1C259-AA

Removal

1. Remove the halfshaft.

Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal and Installation).

Refer to: Front Halfshaft RH - LHD 4WD/RHD 4WD (205-04 Front Drive Halfshafts, Removal and Installation).

2. Discard the grease.

4. General Equipment: Puller

Installation

NOTE: Make sure that the component is clean, free of foreign material and lubricant.

1. Special Tool(s): 308-046

4. Material: Grease FD-R (WSS-M1C259-A1 / 3M5J-M1C259-AA) grease

5. Release any trapped air.

General Equipment: Flat-bladed screwdriver 1.

4. General Equipment: Flat-bladed screwdriver

6. Special Tool(s): 204-169 Torque: 21 Nm

7. Install the halfshaft.

Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal and Installation).

Refer to: Front Halfshaft RH - LHD 4WD/RHD 4WD (205-04 Front Drive Halfshafts, Removal and Installation).

Front Drive Halfshafts

Front Halfshaft LH (14 320 0)

Front Halfshaft RH - LHD 4WD/RHD 4WD

Inner Constant Velocity (CV) Joint Boot (14 336 0)

Outer Constant Velocity (CV) Joint Boot

Halfshaft Bearing